Summary of matters needing attention in gravel pump operation


Published:

Jun 17,2024

Summary of matters needing attention in gravel pump operation

Gravel pumps are mainly used for continuous transportation of highly abrasive materials that cannot be transported by general slurry pumps because the particles are too large. They are suitable for dredging, sucking gravel, dredging rivers, mining, and metal smelting slag transportation.
So what are the precautions for gravel pumps in actual work?
1. Before use or after every month of use, ask an electrician to check whether the insulation resistance is qualified and the line installation meets the requirements.
2. The leakage protector should be tested at least once a week. If it fails during the test or use, it should be replaced in time.
3. The mortar pump should be started in time with the upper and lower processes. The packing of the slurry tube should not be too tight or too loose when tightening the screws.
4. It is forbidden to touch the mortar pump with your hands or directly pull, pull, or lift the body of the mortar pump with the mortar pump wire when the switch is on to prevent the wire head from loosening and the metal casing from being electrified.
5. Protective equipment must be worn when operating the mortar pump.
6. Comply with the general safety operating procedures of electrical porcelain workers.
7. The mortar pump must be used and managed by a dedicated person, and the power supply must be cut off after get off work.

Keyword: