-
ABOUTThe group company integrates design, casting, production, research and development, sales and service to provide customers with modern, digital one-stop water supply system solutions.
-
PRODUCTS
-
APPLICATION4 production bases in group company, 10 branches, more than 20 offices, more than 1000 professional employees, long-term service to domestic and foreign high-end customer groups including Five state-owned power groups.
-
NEWSShanglishi Group is the main member appointed by the Pump Association to participate in the development of national standards for slurry pumps and petrochemical centrifugal pumps.
-
CONTACTThe company's good product quality and service have always created value for customers, and are favored by more and more customers.
Troubleshooting Methods for General Self-Priming Pump Failures
Published:
Feb 28,2024
The following are some common faults, causes and troubleshooting methods of self-priming pumps during use.
The following are some common faults, causes and troubleshooting methods of self-priming pumps during use.
Fault 1. The motor does not rotate
Cause of failure: 1. The motor is damaged 2. The power supply is blocked
Troubleshooting method: 1. Repair or replace the motor 2. Check the power supply
Fault 2: The water pump does not discharge liquid
Reasons for failure: 1. Insufficient drainage fluid 2. Large amount of air leakage from the suction end flange, valve or pipeline 3. The nut of the drainage port or vent is not tight, or there is no washer in the nut 4. There is no liquid in the container or liquid pool
Troubleshooting method: Check one by one and eliminate
Fault 3: Flow and head (pressure) are not up to standard
Reasons for failure: 1. The voltage is too low and the speed is not enough. 2. The motor is reversed. 3. The bottom filter is clogged and the flow is insufficient. 4. Chronic air leakage in the suction end flange, valve or pipeline affects the vacuum of the water pump. 5. Container or There is too little liquid in the liquid pool, and air is sometimes sucked in.
Troubleshooting method: Check one by one and eliminate
Fault 4. Leakage at the connection between the motor and the water pump
Cause of failure: leakage all the time during operation. (It may be that the sealing device is damaged)
Troubleshooting method: Check the sealing device
Keyword:
Self-priming
Previous:
Recommended
SHANGLISHI PUMP GROUP
Department Director: Ms. Wang
Tel: +86-311-82725800/82725629
Email: admin@sls-pump.com
WhatsApp: +86 15830676372
Mobile Website
Mobile Website
Copyright © 2022 SHANGLISHI PUMP GROUP