Common Problems and Precautions when Using Slurry Pump Bearing Components


Published:

Jan 09,2024

During use, bearing components are prone to the following two problems: the bearing temperature is too high; and the bearing components are damaged quickly.

Common Problems and Precautions when Using Slurry Pump Bearing Components

During use, bearing components are prone to the following two problems: the bearing temperature is too high; and the bearing components are damaged quickly.

Causes of excessive temperature:
1. The bearing is improperly adjusted and does not meet the assembly standards.

2. Too much grease, too little grease or impurities

3. Improper selection of slurry pump and excessive power

Reasons for rapid damage:
1. The quality of the bearing itself is not good.

2. The assembly does not meet the standard, or there is dirt in the grease.

In order to ensure that the bearing assembly can meet our working requirements and operate normally, the following matters must be paid attention to when using it:
The emphasis on slurry pumps should be increased. Slurry pumps play an irreplaceable role in production and must be operated in strict accordance with working performance, technical standards and usage standards.

A. Make sure the outside is clean and free of dirt when in use. If it is not clean, improper adjustment of the shaft seal will reduce the heat dissipation performance. There are also cases where the pump is not concentric when closing the pump, and the belt is improperly adjusted, causing the bearing to heat up and causing premature damage to the bearing.

B. Oil should be refueled on time and maintained regularly. Clear away the dirty oil, bad grease, and debris in the bearing. Irregular refueling and maintenance may cause poor operating conditions of the bearing and reduce its service life.

C. The vibration of the slurry pump during operation should be reduced to prevent the various components from loosening to avoid accidents and reduced service life.

D. The above issues should be paid attention to during use, but the most fundamental thing is that the slurry pump manufacturer should strictly follow the technical standards for installation of bearing components during assembly to ensure the initial quality and performance of the bearing components.

The bearing assembly of the slurry pump is the heart of the entire pump. Although its value is not large compared to the entire pump, if the installation does not meet the technical requirements, the normal use of the entire pump cannot be guaranteed and will have a negative impact on the slurry pump. Therefore, in the slurry pump During operation of the slurry pump:
A. Improve the operator’s sense of responsibility and provide appropriate technical training.

B. Make a corresponding operation process

C. Operators and repairmen should cooperate well to use and maintain the slurry pump.

D. For new pumps or newly installed bearing components, the bearing temperature must be observed and controlled to operate at normal temperatures. Do not operate at excessively high temperatures for a long time, otherwise the bearings will be damaged.

Keyword:

SLURRY PUMP